ZMax VV and VW OLED / 4 Amp Switch
(Body Only)
NEW VERSION
(BRUSHED) STAINLESS STEEL
NOT A SMOK TECH PRODUCT
Made by Sigelei
When a new battery is placed in the unit, you must click the power button 5 times rapidly to turn the device on.
This is the newest version of the Zmax. The revisions include a new PCB for better tuned voltage and wattage. It also has the new 8th menu option which changes the voltage calculation formula between RMS and Mean as well as the new and easily readable OLED screen.
Contents:
1 Zmax OLED Body
1 Extension cap
Recomended Batteries
This Mod/APV has 510 threading with a deep well that will allow for use with MOST eGo accessories.
Zmax is a new intelligent e cig Mod, not only can you adjust the voltage, but you can also adjust the wattage. It will work with 1 18650 IMR High Drain Battery or 2 18350 IMR High Drain Flat Top batteries with extender cap. This mod produces consistent voltage and consistent wattage.
1. Zmax can be adjusted from 3.0-6.0V volts in 0.1 volt increments.
2. Built-in three digit display allows you to visually adjust your voltage and wattage.
3. Zmax could fit one battery 18650 or with an extension cap and can hold 2 18350 High Power Batteries with reverse connect protection.
4. ZMax is made of brass and stainless steel.
5. Zmax is with 510 thread with a deep well.
6. With a maximum output of 15 watts.
7. ZMax can be adjusted power from 3.0 --15 W in 0.5 watts increments.
8. ZMax PCB allows 4 Amp output limit.
9. ZMax button never gets stuck, the button allows for 360° turning
Instructions:
When a new battery is placed in the unit, you must click the power button 5 times rapidly to turn the device on.
- 3 Clicks option 1 turn on off
- 4 Clicks option 2 – Voltage UP
- 5 Clicks option 3 - Voltage Down
- 6 Clicks option 4 - Battery Voltage is displayed
- 7 Clicks option 5 - OLED Display to change voltage, power or resistence.
- 8 Clicks option 6 - OLED on/off
- 9 Clicks option 7 - Change setting between voltage and wattage
- 10 Clicks option 8 - Change between RMS/Mean. RMS is the recommended setting.
Warranty and Replacement info:
15 days replacement on defective parts or DOA, beginning from the date shipped. No Refunds. Physical damage is not covered by the return policy. The customer is responsible for paying to ship the defective item to Vapingzone for warranty replacement.
An item may be replaced one time under warranty.
Sorry, but there is no warranty or replacement on atomizers, cartomizers, clearomizers or tanks.
E-liquid must be filled properly and maintained to avoid a burnt taste.
Recommended Cartomizer/Atomizer:
3V-4V for 1.5ohm,4V-5V for 2.0-2.5ohm,5V-6V for 3.0ohm.